Battle Chess Enhanced CD - Windows
| Platforms: | Windows 9X | |
| System Requirements: |
|
|
| System Recommended: | ||
| Installation Tips: | To Install Game: DOS Installation - NOTE: If your CD-ROM drive is an external drive, make sure you have hooked up headphones or speakers to the CD-ROM drive, since all the music, sound effects, tutorial sound, and combat effects are played directly from the CD-ROM drive. If your CD-ROM drive is an internal drive and you have a sound card, make sure a cable connects the internal sound output jack to your sound card to mix the sound sources. See your sound card's manual for further details.
To Start Game:
To Quit Game:
In Windows - |
|
| FAQ: | 1. Problem: No background music or combat sounds.
Solution: Connect a set of speakers to the headphone jack on the CD-ROM drive. Make sure the sound patch cable is installed from
the audio out port on the back of the CD-ROM drive to the CD sound in port on the sound card. 2. Problem: No animation. Solution: Not enough conventional memory free. This game requires 550K conventional memory and 1024K free expanded memory. 3. Problem: Can't find "INTERPLAY.CMP". Solution: Change active drive to the CD-ROM drive. Switch active directory to "CDCHESS" directory. Then run the "INSTALL" program. 4. Problem: Upgraded to MS DOS version 6.0 and can't use CD anymore. Solution: Use "MSCDEX.EXE" version 2.22 or later that should be located in the "DOS" directory. 5. Problem: Receive "CDR-101 not ready error Abort, Retry, or fail?". Solution: The CD-ROM is not in the drive, the CD-ROM is bad or is incompatible with the CD-ROM drive. 6. Problem: The game quits out to DOS with a low memory error message. Solution: The mouse driver may not be compatible. The mouse driver must be 100% Microsoft compatible. 7. Problem: Game is in a small window in the upper left hand corner of the screen. Solution: The screen resolution is set to high. To get a full screen game, screen resolution must be set to 640x480x256. 8. Problem: When using a Sound Blaster, getting the error message: "Sound hardware not found". Solution: Verify the Sound Blaster is set to the following settings:
IRQ 7 or 5, Base I/O Address 220, DMA 1. |